Type S Seats - How to clear SRS?

[sippyyy]

I have searched and searched some more but I cannot find an answer to whether or not you can clear the SRS light with Type S Leathers installed. Can anyone advise?

[Jukka]

to make sure it doesnt come on, you have to make an SRS bypass jumper. or you can buy em on ebay now too. as for clearing the srs light, u gotta go to the dealer i believe.

[usedep3]

to make sure it doesnt come on, you have to make an SRS bypass jumper. or you can buy em on ebay now too. as for clearing the srs light, u gotta go to the dealer i believe.

not neccessarily.

OP did you forget to disconnect your battery before doing the seat swap? if so, you can just reset the SRS light with this: link (http://forums.clubrsx.com/showthread.php?t=308198)

did you remember to swap out the RSX buckles for the ones found on your old ep3 seats?

did you have side airbags on the ep3 seats?

[sippyyy]

The seats were already swapped when I got the car, I'm pretty sure none of the buckles were swapped out. Right now, none of the plugs are plugged in. I wasn't sure if the plugs match up or if it was safe to plug them in so I haven't tried plugging them in yet. I tried doing a SRS light reset but it just came back on. No clue if the old seats had air bags but the new ones do.

[usedep3]

you need those plugs plugged in. the srs light is on bc there is a break in the circuit where the plugs are disconnected. plug them in and reset the light.

[sippyyy]

welp that was easy, no more annoying red light.

[usedep3]

glad you got it :thumbu:

[StockTexasEP3]

Do the RSX leathers sit lower than stock EP3?

[usedep3]

yes. they are lower

[sippyyy]

and much more comfortable. IMO

[StockTexasEP3]

Anyone got specs on how much lower?

[usedep3]

maybe an inch, if that. i mean, there isnt much room to go too much lower than that without putting the seats directly onto the floorpan without any rails lol