imthebro
10-18-2011, 06:45 PM
Hi
I'm looking for information in regards to my planned k20z3 tranny swap over the winter.
the car is running a k24a2 tsx engine on the stock ep3 5 spd tranny and the combo sucks big time.
too much power for a non lsd tranny and terrible gearing for track use ( not so bad for solo II given the tall 2nd gear).
thus I already know it's a pretty simple process of swapping transmission internals and speed gear and the what not, but i'm curious to know if I i will be able to reuse my current clutch (Bully stage 3, 4 puck clutch) and EP3 flywheel ?
(clutch has 3500k kms on it, 2000 done on track :mtongue: )
I'm guessing I can reuse it since I'm reusing the ep3 casing...
Anything special I need to know regarding throwout bearings ?
thanks
I'm looking for information in regards to my planned k20z3 tranny swap over the winter.
the car is running a k24a2 tsx engine on the stock ep3 5 spd tranny and the combo sucks big time.
too much power for a non lsd tranny and terrible gearing for track use ( not so bad for solo II given the tall 2nd gear).
thus I already know it's a pretty simple process of swapping transmission internals and speed gear and the what not, but i'm curious to know if I i will be able to reuse my current clutch (Bully stage 3, 4 puck clutch) and EP3 flywheel ?
(clutch has 3500k kms on it, 2000 done on track :mtongue: )
I'm guessing I can reuse it since I'm reusing the ep3 casing...
Anything special I need to know regarding throwout bearings ?
thanks