DP420
12-01-2011, 05:35 PM
k24a2 swap
injen cold air
rbc mani
just replaced my engine harness with a 02 harness
ran fine for the first couple of minutes
CEL came on with a p1106 baro sensor range/ performance..
now i went from 1st to 2nd then the idle redlined at 7500
checked the hood for the throttle cable to check if it was touching, so i left the hood cracked
and tucked the throttle cable to the side.
drove home about half a mile. checked my kpro and i got the same code ive been reading that it might be a bad ecu?? just need to make sure if it is... hopefully its not!
http://forums.clubep3.com/showthread.php?t=685577
this link ^ i read some good things. but need to confirm it...
HELPPP
injen cold air
rbc mani
just replaced my engine harness with a 02 harness
ran fine for the first couple of minutes
CEL came on with a p1106 baro sensor range/ performance..
now i went from 1st to 2nd then the idle redlined at 7500
checked the hood for the throttle cable to check if it was touching, so i left the hood cracked
and tucked the throttle cable to the side.
drove home about half a mile. checked my kpro and i got the same code ive been reading that it might be a bad ecu?? just need to make sure if it is... hopefully its not!
http://forums.clubep3.com/showthread.php?t=685577
this link ^ i read some good things. but need to confirm it...
HELPPP