ImportCustomx
01-16-2012, 08:09 AM
Hi everyone,
So i have a bit of an issue.
I installed an Omni Power Clutch Master Cylinder a few months back, it has been working. Recently i blew the line from the new Omnipower CMC... I am going to see if i can call omnipower and get another, but before i waste any of my time etc, i need to know if goodridge or anyone else makes a line that replaces that piece. or that replaces the entire section up the OEM brakeline tubing that connects to the slave.
http://farm8.staticflickr.com/7001/6705176367_9fceed793a_z.jpg
Attached is a picture of the carnage..not sure how it happened..very odd. It was a little chilly out today (7 degrees) pumped the clutch a few times and then wammo..to the floor.
Link me up.
So i have a bit of an issue.
I installed an Omni Power Clutch Master Cylinder a few months back, it has been working. Recently i blew the line from the new Omnipower CMC... I am going to see if i can call omnipower and get another, but before i waste any of my time etc, i need to know if goodridge or anyone else makes a line that replaces that piece. or that replaces the entire section up the OEM brakeline tubing that connects to the slave.
http://farm8.staticflickr.com/7001/6705176367_9fceed793a_z.jpg
Attached is a picture of the carnage..not sure how it happened..very odd. It was a little chilly out today (7 degrees) pumped the clutch a few times and then wammo..to the floor.
Link me up.