Buddy Club ball joint wonders?

[Mortification1]

Well apparently i think my ball joint is messed up. And i was looking for replacements and apparently HONDA doesnt sell them? Only aftermarket on ebay. Or the buddy club ones. The buddy clubs are about $185 and say they for dropped cars. Can anyone chime in on what makes these so special.

Here are some pix of my damage :(

http://i241.photobucket.com/albums/ff317/Mortificationrock/IMAG0432.jpg
http://i241.photobucket.com/albums/ff317/Mortificationrock/IMAG0431.jpg

All i hear is clunking sounds from this side where i found the above^^

[geeio]

There are after markets you can get. i bought mine at napa for about 40 bucks there are cheaper places as well but i wanted to get them done at the same time i was doing my wheel bearings, the buddy club ones are nice they are taller so if you have a lowered car it would lower the control arm to make it closer to what the stock geometry is supposed to control the roll center of the car,

[tinman5]

Same here. Picked up my Moogs from Advance for just under forty bux a piece. I am pretty confident that the Moogs also come with grease zerts. If not this application, than i am thinking the S13, as i did that car around the same time.

[whatsvtec]

Moog does come with a grease fitting. Go MOOG if you're only dropped a little or stock height. Deff get RCA ball joints if you're excessively lowered.

[Mortification1]

All right guys...thanx for the input. I found the pair for 40 on enay but im guessing they suck? Lol :P