Ephatch >
Tune-Up >
Engine > Any differences in bolt pattern on k20, k20a2, and k20a3 exhaust manifold??
View Full Version : Any differences in bolt pattern on k20, k20a2, and k20a3 exhaust manifold??
Well I'm testing out some ideas and been researching all over the internet, is there a difference in bolt pattern on the k20a, k20a2, and k20a3?? Or are they all the same meaning a exhaust manifold meant for any of the engines can fit on any of the heads?
No. They all bolt right up. Only issue you can have is sway bar clearance.
I have no problem helping out, but I see this time and time again with newer people.. But, SEARCH! Nothing on here is hard to find. Everything is labeled specifically.
Blah1219
01-25-2012, 12:48 AM
The only thing different between the a3 vs a2/z1 race header is that the a2/z1 is 2.5" longer. So you would need a type-s midpipe or custom midpipe.
herp a derp read my signature. its only posted about 1,700 times by now.
herp a derp read my signature. its only posted about 1,700 times by now.
http://farm8.staticflickr.com/7144/6758534487_57e75c01bb_b.jpg
:cclap:
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.