View Full Version : Help just installed new head k20a2 but make noise
jarsir
03-30-2012, 09:33 PM
Hi guys I just done the head job but I start it up the valva make noise timing is right i did adjust valve (intake 0.23 exhaust 0.27)everything but still the same and I drive it 180 mile the car run fine And all the way to 8600 rpm with no problem so the super tech valve should be make noise ?is that normal ?or I did something wrong ?
Euro-Yellow-Ep3
03-30-2012, 09:37 PM
ur bringing the a3 bottom end to 8600 rpm, no wonder your hearing noises, good luck bro
jarsir
03-30-2012, 09:46 PM
ur bringing the a3 bottom end to 8600 rpm, no wonder your hearing noises, good luck bro
O my bad I got k20a2 swap
bro post up in norcal forum (also), or hit me up to take a look at it.
the valvetrain is always noisey. did you rotate the crank when you moved to a new cylinder/valves?
Euro-Yellow-Ep3
03-31-2012, 07:04 AM
O my bad I got k20a2 swap
ok, def get a second opinon on your issue
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.