K-Series Crank Pulley Diameters

[iDom]

Before I get sassed, I would like to say that I first looked and searched the forums and couldn't find what I was looking for, so.. I would like to start this thread and hopefully fill it up. I have a k24a2 with a k20z3 head, and i'm not sure which Crank Pulley is on it. I already bought a OEM belt for the k20a3 and planned to use that but am unsure of which Crank Pulley is on the engine. (It's either the k20z3 or k24a2 Crank Pulley) I can't be sure which is which without knowing the Diameters in inches, so along with finding the answer to my question, I am hoping to make a thread with some useful info..

Yes, I know I can just swap my k20a3 Crank Pulley from my stock motor over, but I would still like to know which one is on the engine/or if I'll even have to..


Part #: 13810-RRA-A02
Found in:
2002-2006 Base RSX (k20a3)
2002-2005 Civic Si (k20a3)
2004-2008 TSX (k24a2)
2002-2006 CR-V (k24a1)
2003-2005 Accord (k24a4)
Diameter: 6.125"

Part #: 13810-RZA-A01
Found in: 2007-2009 CR-V (k24z1)
Diameter: 6.50"

Part #: 13810-RAA-J02
Found in: 2006-2007 Accord (k24a8)
Diameter: ???

Part #: 13810-RRB-A01
Found in:
2006-2011 Civic Si (k20z3)
Diameter: 5.75"

Part#: 13810-PRC-003
Found in: 2005-2006 RSX Type-S (k20z1)
Diameter: 5.40"

Part# 13810-PRB-A01
Found in: 2002-2004 RSX Type-S (k20a2)
Diameter: 5.80"



http://www.ezop.com/wp-content/uploads/Fraction-to-Decimal-Conversion-Chart.jpg

More to Come

[iDom]

Well this has been a smashing success.. Haha

Anyone with any of the listed swaps feel like going under their car or next time they do an oil change just get a quick measurement?

[MugenReplica]

http://www.superhonda.com/photopost/data/501/k-series-crank-pullies.jpg


Good list!!

[MugenReplica]

03 crv k24 crank pulley diameter is 6.25 inches
06 civic si k20z3 crank pulley diameter is 5.75 inches
08 crv k24 crank pulley diameter is 6.5 inches
03 accord v6 crank pulley is 7.0 inches ( im not sure if the snout is the same diameter on the crank, but it has the same number of ribs and is a single belt pulley)
Stock TSX steel crank damper dia------ 6.125", 4.6 lbs.
Stock K20A2/PRB steel crank damper----5.80", ___ lbs.
Stock K20Z1/PRC steel crank damper----5.40", 4.2 lbs.

Here's what I was able to locate quickly. Sorry for the delay.

[iDom]

UPDATED

Nice! Thanks

Are you sure about the 03 CR-V being 6.25? The part #'s for the 02-06 CR-V and all the other engines match the 13810-RRA-A02 part number.

Other than that, and besides the JDM engines (which I can never find jack squat when it comes to those) I think that about covers it.