Streaks on rotors after resurface?

[nolaEp3]

I was just wondering if this looks normal. I've looked around and seems to be. I recently got my rotors turned, i have a brembo gt kit. When i installed them back and drove about 50 miles this is what they now look like. I'm thinking its because I'm using the old pads and they just need to even out but just wanted some other opinions. Thanks

http://i.imgur.com/uNYkT.jpg

[AttarixEp]

Needs a few more 1000ths cut off. The dark is the low spots. It will continue to wear uneven in time and start to overheat.

[RHCP0801]

when you replace rotors or get them resurfaced, you're supposed to use new pads not old ones

[nolaEp3]

Yea I know but money is a bit tight and a new set of pads is about $110.

Sent from my SPH-D700 using Tapatalk

[RHCP0801]

should have waited to get the rotors resurfaced until you had enough money to do it all. Now you're going to need to get them resurfaced again once the new pads come in

[nolaEp3]

Its all good,I get them done for free, good friend works at oriley :)

Sent from my SPH-D700 using Tapatalk

[RHCP0801]

yea but you can only cut them so many times before they get too thin