View Full Version : Streaks on rotors after resurface?
nolaEp3
05-22-2012, 09:29 PM
I was just wondering if this looks normal. I've looked around and seems to be. I recently got my rotors turned, i have a brembo gt kit. When i installed them back and drove about 50 miles this is what they now look like. I'm thinking its because I'm using the old pads and they just need to even out but just wanted some other opinions. Thanks
http://i.imgur.com/uNYkT.jpg
AttarixEp
05-23-2012, 09:10 AM
Needs a few more 1000ths cut off. The dark is the low spots. It will continue to wear uneven in time and start to overheat.
RHCP0801
05-23-2012, 09:13 AM
when you replace rotors or get them resurfaced, you're supposed to use new pads not old ones
nolaEp3
05-23-2012, 09:40 AM
Yea I know but money is a bit tight and a new set of pads is about $110.
Sent from my SPH-D700 using Tapatalk
RHCP0801
05-23-2012, 02:03 PM
should have waited to get the rotors resurfaced until you had enough money to do it all. Now you're going to need to get them resurfaced again once the new pads come in
nolaEp3
05-23-2012, 04:05 PM
Its all good,I get them done for free, good friend works at oriley :)
Sent from my SPH-D700 using Tapatalk
RHCP0801
05-23-2012, 07:29 PM
yea but you can only cut them so many times before they get too thin
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.