4.0 to 4.4 pulley? new to Kpro

[gtecd20]

so i have been reading and playing around with kpro but was wondering
the base map for a JRSC is set for 440cc injectors and 4.0 pulley

the street kit im running has the stock 270cc injectors(which i changed the kal) and 4.4 pulley.

So my questions is since im running a bigger pulley where would i go to add that to the kal?

thanks for any help

[differentK]

you dont add pulley size to the kal- the pulley determines blower rpm which ultimately determines the amount of boost generated. you can probably run the 4.0in kal on your 4.4in setup for now- it may run a little rich but it should keep you on the road long enough to either upgrade to the race setup or get a proper tune.

[gtecd20]

K so I uploaded this calibrations to my kpro and I started the car up but now have a problem it won't go past 2500 rpm any help why it's doing this?

[gtecd20]

nevermind just needed an updated reloaded kal all good now