Help!!! did 5 lug conversion too much positive camber

[j0k3r88]

Hi ephatchers i was hoping you guys could chime in on this. I went 5 lug on my 02 ep3 and now my right front wheel is cambered out 2.6 degrees after an alignment i also purchased the spc camber bolts but it only helped a little.
Any other suggestions will be big help thanks

Sent from my DROID RAZR using Tapatalk 2

[whatsvtec]

sounds like you've got a bent knuckle or control arm. Get under there and do some investigation.

[j0k3r88]

I was wondering if it maybe my knuckle but my bearing spins freely no noise or grinds but thanks ill look in to another knuckle

Sent from my DROID RAZR using Tapatalk 2

[b_ron]

Could be the mounts on the knuckle that's bent

[Jpax]

make sure the camber bolt is in the right position on the strut, if you put it on the top hole on the strut your camber will be way off, if you put it on the bottom hole on the sturt you can turn it so it rolls on the cam to angle your strut to give or take away camber. also if you have upper adjustable camber plates make sure it didn't slide to one side by accident. see if you did you fully remove the strut from the car?

[j0k3r88]

Kool ill try switching the camber bolts from the top to the bottom. but by doing that will it ruin my alighnment