ball joints..

[sp00n sp0rts]

i was wondering if anyone knew a way on how to take of a ball joint the easy way instead of having the ball joint remover tool thanks God Speed..

[m3nace]

Bang it out with a soft mallet

[m3nace]

Just go to auto zone and rent it itll save alot of time lol and youll get your money back

[.colin]

From the knuckle or the LCA?

[sp00n sp0rts]

From the knuckle..

[SkareKrow]

From the knuckle..

Bang it! But make sure your replacing it.

Sent from my SPH-L710 using Tapatalk 2

[sp00n sp0rts]

ok so the installation would be the same way jus bang it?

[Canuck Civic]

I wouldn't bang it in. If you have a vice or a c clamp try that. If you do resort to banging in make sure it goes in straight.

[sp00n sp0rts]

ah ok thanks for the help guys.. God Speed..

[Mighty_Mouse_Ep]

I used a tool i got from harbor freight it was about 20 bucks and worked like a charm. The tool should look like this.
http://www.harborfreight.com/3-4-quarter-inch-forged-ball-point-joint-separator-99849.html
http://images.harborfreight.com/cpi/photos/99800-99899/99849.gif

[Hasbro]

I used a tool i got from harbor freight it was about 20 bucks and worked like a charm. The tool should look like this.
http://www.harborfreight.com/3-4-quarter-inch-forged-ball-point-joint-separator-99849.html
http://images.harborfreight.com/cpi/photos/99800-99899/99849.gif

Same here.

[EP3driver]

I looked in a Honda parts online site but could not find the front ball joint listed in the chassis parts or elsewhere...I need to order the front ones. Anyone has a Honda P/ N?