PDA

View Full Version : Cant hit full throttle help please!!!



b33lz89
06-11-2013, 07:24 PM
I got a CAI and it was raining while I was driving.. highway was kinda flooded and I believe i got water in the intake... long story short.. all the sudden my car started acting up and got a CEL P0134 (Air Fuel Ratio (A/F) Sensor) according to kpro... I pulled over turned the car off then on and it was revving on its own from 1k-2k.. looked it up today and I found out that all u need to do is clean the IACV... did that and it fixed the problem car runs fine except that the gas pedal feels a lot shorter.. I barely touch it and its hitting the floor.. looked in kpro and when I hit the gas pedal all the way it only goes to 60% throttle ... I didnt touch the throttle cable, adjust it or anything.. what could be wrong?

b33lz89
06-12-2013, 08:55 AM
bump... anyone??

Canuck Civic
06-14-2013, 09:44 AM
What I would do is ensure when you do press the throttle to the floor the throttle body does open 100%. You will have to remove intake to verify. If the butterfly does open 100% then the cable and throttle is not the issue.

You would then just recalibrate the TPS in kpro.

What does it show in Kpro when the throttle is not pressed?