View Full Version : RSX/EP3 ABS Tone ring
captaingamez
01-08-2014, 10:42 AM
I just bought a Type S axle for my CTR 5 lug swap, and it has no tone ring on it.
The Tone ring is the ring for the ABS sensor on the outboard CV joint.
Can somebody measure a DC5 base model, or EP3 axle and tell me what it measures? I need it measured on the collar where the tone ring slides on to.
I would seriously appreciate this info.
USAF EP3
01-10-2014, 06:13 PM
The only information I can give you is that the stock EP3 ABS sensor sits too close to the 36mm DC5-S axles and you have to shim it with some washers.
I have found success with (2) 1/8" thick washers and it PERFECTLY spaces the ABS sensor to the DC5-S axle ABS ring. I haven't measured it with my feeler gauge, but I would say it's about .10"-.12" close.
Hope this info helps, you could possibly measure your stock axle ABS ring and do some math and add the thickness of the washer I used to get a rough estimate of the DC5-S axle.
captaingamez
01-17-2014, 01:11 PM
Thanks for the heads up, I just ordered a new axle, but I didnt know about the abs sensor, I have the sensors that came out of the CTR so I should be good to go by just swapping the sensors out
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.