-
Here is the backside of the platform with the excess foam trimmed off
http://i54.photobucket.com/albums/g9...nterior061.jpg
And the topside
http://i54.photobucket.com/albums/g9...nterior062.jpg
The foam will need to cure a little longer inside(it got cold last night in the garage) and then I will add the exterior S-glass and then get everything mounted.
-
Ok got a bit more done now that I got some more Epoxy Resin. The foam side recieved 3 layers, E-glas/Kevlar/E-glas, the top recieved 3 layers, E-glas/Cf/E-glas
I didnt think having an exposed layer of CF around all those amps was a good idea, and why it is top layered with E-Glas
Top view, battery, 100 amp breaker, hot 12vdc distribution block, Cap, switched power block w/relay
http://i54.photobucket.com/albums/g9...nterior063.jpg
Side view, notice the bottom profile
http://i54.photobucket.com/albums/g9...nterior064.jpg
This will be then glued/bolted to the chassis under the amp rack. I will have a total of 10 additional available circuits, 4 hot and 6 switched +12vdc.