MoonSi - socal - EP3 *Build Thread*
http://farm5.static.flickr.com/4107/...77b586c7_b.jpg
http://farm5.static.flickr.com/4087/...def4a4f4_b.jpg
http://farm7.static.flickr.com/6183/...2030d9eb_b.jpg
04/02/10
http://farm3.static.flickr.com/2722/...efc61ac2_b.jpg
Taking transmission out
http://farm5.static.flickr.com/4072/...ced16ca4_b.jpg
New subframe is replacing old subframe.
http://farm3.static.flickr.com/2763/...2cc207a1_b.jpg
Transmission is getting Gear-X short ratio gears, 5.08 final gear, carbon synchros, new bearings, and wavetrac LSD.
http://farm3.static.flickr.com/2752/...d4086d12_b.jpg
Gear-X main shaft
http://farm3.static.flickr.com/2740/...24673eb3_b.jpg
Gear-X one of the short ratio gears
http://farm3.static.flickr.com/2788/...681bcaf4_b.jpg
These gears were used in 25hr enduro race, rally, and many serious race conditions
Contact me if intereted in Gear-X, Hardrace, or special project products.
03/27/10
http://farm5.static.flickr.com/4002/...6ea2802b_o.jpg
In the process of building front splitter that fits with 02-03 CTR bumper with Mugen Lip
Custom bracket will be bolted on to chassis, and the splitter will be very easy to put on with removable pins.
Splitter itself is made out of plywood, which is very cheap and easy to replace.
Air flow under the chassis will increase its velocity by putting this splitter and definitely gives more downforce. This will work awesome with undertray + rear diffusers.
If you have same front setup as mine, you will be able to purchase same kit from special project motorsports.