Can anyone tell me were the knock sensor is located at?
Sent from my Samsung Galaxy s3
Printable View
Can anyone tell me were the knock sensor is located at?
Sent from my Samsung Galaxy s3
In the front of the block, right below the intake manifold. Let me know if you need to know how to replace it.
Sent from my iPhone using Tapatalk
Thanks. Do u know how to install it? Do u know were I can get a new knock sensor and how much is it going to cost?
Sent from my Samsung Galaxy s3
You can get them from rockauto.com - search for a knock sensor, price is 35 - 45 bucks.Quote:
Originally Posted by kandm01012011
As far as replacing it, it's pretty easy.
1)First you need to go buy a 27mm socket.
2)Remove the splash shields underneath the front bumper so you can get your hand up underneath the intake manifold. If you're a skinny dude, you may be able to bend them out of the way to get your arm up.
3)Locate the knock sensor, unplug the connector. It's directly below the intake manifold. If you shine a flashlight through the opening between the 2nd and 3rd runners, you can see it.
4) Use a socket wrench and the 27mm socket to remove the bad sensor.
5) Replace the sensor, tighten down with the 27mm socket.
6) Plug it in
mine just went out also good thread hope to get my cel off with this replaced
Thanks you so much. I been driving with my check engine for about 2 weeks already.
Sent from my Samsung Galaxy s3
Anyone have photos of where the knock sensor is, I cannot locate it, the one thing i miss about my EG is that i had room to work.
These are drastically easier to work on once you get used to where everything is, especially once you remove an engine/tranny a few times.Quote:
Originally Posted by ur2slow4j
Does anyone how to tell if the new knock sensor is bad? I just change it and clear the light with snap on scan tool but light came on once again
https://i.ibb.co/fNWFwf8/cock-sensor...-2003-USDM.jpg
**NOTE** The knock sensor should be torqued to spec (23 ft lbs). If its not, it may not read correctly.
This wouldn't be the cause of your issue, im just including it since were on the subject of knock sensors.
https://i.ibb.co/5Mbxy0f/2019-06-18-180221.jpg