you may rub in the rear without a little camber...i do with the same setup
best way to clean and dry AEM v2 intake cone?
Tap to remove dust and dirt. Spray with water. Dry. Maybe use hair dryer? Re-install?
hahah the badge will go right back into the grill, but the adhesive might not stick anymore
Here's a fun one;
picking up used K24A1 cams for use as replacements for my galled-ass K20A3 cams. (Same cams, different name, so they fit, not to worry! :D)
Question is, do the valve lash specs change? I mean, they should be the same, right? It's like putting some A3 cams in there, so no change to specs...right? :shrug:
I dont know if a hair dryer will affect it. Try it let us know. I dont have a V2 either, I have the AEM CAI, I just tap it so it removes the dust then I just put it in a 2 gallon bucket of HOT water and I twist it Vigorously. Then I let it air Dry. Should be good after that.
Wheres the Idler pulley? is this the same as the autotensioner pulley? Whats the recommended mileage of replacement?