DIY: Power Plenum Install
my engine bay is dirty because i have no outside faucet, no money, and i live in the north east, also it was winter time hence the hoodie, so unless you want to clean my engine bay STFU, i know its dirty
First you will need to prop the hood open for easier access ;)
http://i27.photobucket.com/albums/c1...w/100_0677.jpg
http://i27.photobucket.com/albums/c1...w/100_0676.jpg
(I removed my front bumper but i only have 4 bolts holding it on so it was just easier for me.)
Then you need to remove the radiator support, there is a little 10mm bolt at the bottom that is a bitch to get to. you also need to unbolt the radiator and ac condenser from the support, but i shouldn't have to tell you that.
http://i27.photobucket.com/albums/c1...w/100_0683.jpg
You will then be able to tilt the radiator forward and freely get to the 6, 12mm bolts on the underside of the intake.
http://i27.photobucket.com/albums/c1...w/100_0685.jpg
http://i27.photobucket.com/albums/c1...w/100_0686.jpg
Once those are removed replace the intake plate with he spacer and remember the gasket, you will replace the bolts with the ones int he kit.
Now your done Installing and you can just redo the steps to put everything back together and your ready!.
BTW, this is what i found in mine
http://i27.photobucket.com/albums/c1...w/100_0684.jpg