just picked up 5 lug conversion from a 04 ep3 and the ball joints have a lotta play and goin to replace them... any suggestion where i can get them??
Printable View
just picked up 5 lug conversion from a 04 ep3 and the ball joints have a lotta play and goin to replace them... any suggestion where i can get them??
www.hondaautomotiveparts.com
or
find a set of RCA's (roll center adjusters)
Christian
does the rsx have the same ball joints has the ep's??
Nope, they are two separate part #'s
02-05 Ep3 and 02-04 RSX all share the same ball joint size. Only the 05-06 RSX have the larger ball joints.
I just bought a couple on ebay for 52.00. There comparable to the moog.
i was think ordering off ebay too
Not to thread jack but if you have driveshaft shop axles in your car and go to replace you lower ball joints with the Moog's be sure to remove the grease Zerk and replace it with a top cap because since the driveshaft shop axles are bigger and thicker than the OEM Honda axles the grease zerk will rub against the axle. I had to do that since I recently replaced my lower ball joints with the moogs.
A 90 degree zerk fitting will clear the DSS axles CV unit.
www.rockauto.com has lots of oe goods for cheap prices
Then which ones come with the ball joints, those appear to be 90 degrees to me but I may be mistaken.
http://www.autopartswarehouse.com/sk...n+%26+Steering
Here is a pic. Isnt that the 90 degree zerk in that pic?
I have this probleme with the moog ball joint. I can't install my axels if I keep the greese thing. Why they sell them if it does'nt fit.
http://www.rockauto.com/catalog/moreinfo.php?pk=926101
Is this all I need if my ball joints are done? Cause I called Honda and they said I have to order the whole knuckle, at $400 a piece :(