DIY - Ebay Fog Switch to LED's

Tools needed:
Soldering Iron
Rosin 60/40
2x 510 Resistors
1x 3mm green LED
1x 3mm clear amber LED
Ebay Fog Switch
Small Drill (about 1/16)

This is a follow up from my old thread:
http://www.ephatch.com/forum/showthread.php?t=44933

http://img.photobucket.com/albums/v4...stepwefwef.jpg
http://img.photobucket.com/albums/v4...ep2wefwaef.jpg
http://img.photobucket.com/albums/v4...ep3wefwaef.jpg
http://img.photobucket.com/albums/v4...hstepewfwe.jpg
http://img.photobucket.com/albums/v4...ggwfgwefwe.jpg
tip: you can use hot glue to add a layer of insulation to keep the resistor from touching the switch. Its up to you

nice, thanks for this.

Not a bad fix, but a new OEM switch is only 14$ and a far better choice for most everyone without any electronics experience.

Quote:

---

Originally Posted by talonXracer

Not a bad fix, but a new OEM switch is only 14$ and a far better choice for most everyone without any electronics experience.

---

Where do you buy your OEM switches from? I would have bought one if I knew it was that much because I bought my fog switch from Acura for ~$30 since they do not sell the switches seperately