need help asap

[Toy2Si]

i need help putting back the whole strut seems like i cant get the holes on rotor assembly to line up with the holes on the strup specially the top hole. please help asap

[Toy2Si]

im talking about this holes, im trying to put it back in.

[DjMacAtack]

push it in while slowly turning the brake rotar...

the cv boot was pulled too far out so u hafta realign the teeth.

you may have to move it a bit if it was pulled too far out... downside is you cant really see what ur doing...

[Jpax]

looks like you should jack up the A arm. ..... under the wheel. then it might align the bolts right. and make sure the CV boot is aligened right.

[02SilverSiHB]

Originally posted by DjMacAtack
push it in while slowly turning the brake rotar...

the cv boot was pulled too far out so u hafta realign the teeth.

you may have to move it a bit if it was pulled too far out... downside is you cant really see what ur doing...

correct.....like dj just said.....
Push in on the rotor, then turn slightly counter clockwise and then start turning clockwise while pushing in still and it should slide back in

[Toy2Si]

thanks for the help guys, that was really hard to put it back one of my friend wrap a towel around it and tried to hit it hard with his palm and it finally went in...again thanks guys...