There are actually a few ways to approach this. Here's a couple:
Mount a small piece of MDF to the seat via screws. Tap 4 small pilot holes in the metal casing of the back of the seat and be careful not too push too hard so that you end up going through the seat cushion. You can paint or carpet the MDF as well for cosmetics. You can either route the wiring through the underside of the MDF (Just raise it with spacers and tap holes) or with some loom. This would be the better of the 2 as you will not introduce any unwanted interference.
Second, mount the amp directly to the back of the seat.
Good luck and take your time.
Bookmarks