Hello would any of you out there happen to know if the base
RSX's OEM side skirts and splash guards will fit our ep3?
Thanks for any information in advance.
Hello would any of you out there happen to know if the base
RSX's OEM side skirts and splash guards will fit our ep3?
Thanks for any information in advance.
Well my reason for the post is this. My girlfriend just
got an RSX base. She is getting the OEM body kit installed
later this week. So I started thinking "instead of throwing
away the old side skirts maybe they might fit in my dam ep3."
I know it's hard to answer if no one has tried it but I
figure someone besides me has tried it.
Well thanks for reading. any thoughts on the matter
would be appreciated.
i highly doubt they'll fit.
put them on eBay.
If you took them to a body shop im sure they could come up with somthing...My friend has 99-00 si sides on his 92-95 hatchie and they look Very good with the Si lip!! Ya never kno...?
Thanks for your suggestions. I will see what I can do with
it and keep you posted. I love my ep but it just looks naked
without anything there. I also think the type r sides look
good but it's too flashy for me. I just want some plain
side skirts.
Thanks again for taking the time to reply.
Update.
Just as everyone said, They don't fit. It was worth a try.
The RSX base side skirts are too short. It's a shame cause
I think it would look alot better with something there and
still keep that stock look.
Back to the drawing board.
Thanks again everyone.
You guys think the splash guards from the rsx would fit a 02 ep3?
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
If someone was looking to do this, I'm in socal, and can make just about anything fit.
Last edited by RickEP3; 05-14-2009 at 04:50 PM.
Just a suggestion, it will NOT be cheap.
Acquire a second pair if RSX skirts, a good body shop, especially one that is familiar with custom and fabrication work can properly cut and join the 2 pairs of skirts into 1 pair the correct length.
I have seen similar things done with JDM front bumpers like the Type X 200sx and RX7 front bumpers that have that ridiculous license plate platform molded into the nose. That section is cut out and using another bumper with the correct contours the protrusion is eliminated.
Again, not cheap, but different enough in a good way. Things like that have a subtle way of standing out.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks