Taking my car in for alignment this morning at NTB. SPC camber kit will be installed. Hopefully they don't give me the chorizo.
Well, everything went OK and they only had to install the rear camber kit. One question I just thought of though. Was NTB supposed to give me back anything from the car? I guess what I'm trying to say is did they REPLACE anything I should have been given back, because I didn't get anything.
Hey...did they give you your alignment spec sheet? Also, what springs or coilovers do you have?
The Original Noob with Boobs
No, they sure didn't. I'm running H&R Springs. Hell I'm such a noob at this stuff I wouldn't even know what I was looking at.
I lied. I do have the spec sheet. It was mixed in with the receipt. Tell me what I need to look for.
Well it should have like 2 columns
It should say something like...camber 1 degree factory allowment -1 degree to 1 degree
etc etc
can you scan it?
The Original Noob with Boobs
I'm gonna go outside and see if I can find one to show you...
Its for my 4 door but should be the same concept you know?
The Original Noob with Boobs
Here it is..
The Original Noob with Boobs
I wish I could scan it but I don't have one. Here it goes:
Left Front:
ACTUAL BEFORE
-0.6 -0.6 (camber)
2.6 2.6 (Caster)
0.00 -0.51 (Toe)
RIGHT FRONT:
Actual BEFORE
-0.3 -0.2 (Camber)
1.5 1.4 (Caster)
0.02 -0.52 (Toe)
FRONT
Actual BEFORE
-0.3 -0.5 (Cross Camber)
1.1 1.2 (Cross Caster)
0.02 -1.03 (Total Toe)
LEFT REAR:
Actual Before
-1.0 -1.8 (Camber)
0.10 0.13 (Toe)
RIGHT REAR:
Actual Before
-0.8 -2.2 (Camber)
0.07 0.41 (Toe)
REAR:
Actual Before
0.17 0.55 (Total Toe)
0.02 -0.14 (Thrust Angle)
Last edited by frentzenej11; 01-08-2004 at 03:46 PM.
shouldn't they have given u ur stock camber for the rear? or did they stick it in the box that the SPC kit came with?
Yeah they didn't give me anything back. I guess I'm gonna go tomorrow and get that sheeot!
Yeah man, go up there and check that. What did the rear camber kit consist of (I haven't seen one for our cars). The front is just bolts with washers and a nut right? Whatever they put in the back...if it is not just a spacer (which in case nothing back would make sense) they should give you in return. Just find out what the parts are and how they actually did it. Cuz it may be that there was nothing to give back you know? :D
The Original Noob with Boobs
Here is a close up shot of my spc kit (on the rear). you cant see it too well, but you'll notice how a zip tie is needed to attach the oem brake sensor to the piece and still be able to adjust the kit.:)
looks like someone sold you Ingalls and told you they were SPC.
You sir are correct! They are Ingals (My bad!), but are manufatured by Gold-Line.Originally posted by 02-sir
looks like someone sold you Ingalls and told you they were SPC.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks