Reply With Quoteit's been awhile, but i think all you gotta do is lift up while pulling out a little.
How does it come off? Is there any way to take it off without breaking the plastic clips that hold it on?
it's been awhile, but i think all you gotta do is lift up while pulling out a little.
Do you know if the black plastic clips just pop out or will they break if I try to pry them out?
i thought the rear plate bracket was screwed into plastic plugs.
i'll go take a picture... hang on...
the plastic clips on the side are removable similar to the interior panel clips. the top metal piece stays.
basically reach behind the plastic frame thingee and use it to pull out the clips on each side then slide up and twist the frame off the top pin (it works easier if the hatch is slightly open). i put the plastic clips back-but you can do whatever.
fyi - i learned how to do this from racerdre in the lot at autobacs (or was it redrobin?)...
uploading pics now...
Last edited by glw; 03-14-2004 at 09:54 PM.
Mine never even came with the holder.
Neato, I was just trying to figure this out myself. :)
just unscrew and pry off, gently they will snap off and no, they wont break
Formerly known as Plainol2k2si
ive been trying to figure out how to do this since i had my 1st ep !
thanks guys.
hmmm... seems easy enough... time to try this DIY out :)
super easy to do but i left the plastic rivet things in there to protect water from getting in the hatch and left the middle metal thing there as well (didnt know how to take it out) but i added some plastic bumpers (things you put under furniture) to protect my metal lisence plate frame from scratching my paint.
Alright I too was trying to figure out how the hell to do this, guess now I know.
Cool I wanted to take it off so I can get it painted to match the car.
Bump for a RE-DO DIY!??? PiCS!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Bookmarks