Reply With Quotethose are some very nice pics! good job... however.. it seems like a task too complicated for me to undertake... this is for the brave souls out there :)
Installed clutch and flywheel lately, and I took a picture of it, so I just thought it will be helpful to post instruction of it.
Link
Last edited by k2ep3; 03-14-2004 at 09:22 PM.
those are some very nice pics! good job... however.. it seems like a task too complicated for me to undertake... this is for the brave souls out there :)
Actually, it wasn't that easy comparing to install intake, but I saved a lot like $400, $500 for installing. :D Well, if you have factory service manual, it shouldn't be that bad. I just thought this would be helpful.
Anyway, thanks.
a manual and air tools. Air tools and a good tq wrench are must haves for a diy'er.
U guys are crazy , this clutch was so hard, and ur directionns sucked real bad
the pressure plate is hard, but it's driveable.Originally posted by Nadal328
U guys are crazy , this clutch was so hard, and ur directionns sucked real bad
it's little heavier than what i was thinking though....
i post all the directions that is needed for the transmission part.
Link is dead. Help?
Last edited by Heitzke; 01-23-2009 at 10:02 AM. Reason: pic tooo big
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Bookmarks