i got my side skirts from showstoppers(i have couple questions)

[caligula]

what's up guys like the title says i just got my side skirts and this is my questions,1 do i need to use double side tape or is not necessary it would just be fine with the two screws on the front and two on the rear, 2 do i need to make any modifications before i get it painted,or should i painted first and then do the modifications.

[Ep3 No.2]

test fit them 1st.
depending on which ones u ordered, u will most likely have to sand em down to fit.
the 2 screws up front and 2 screws in the back should be fine, but u might wanna use double sided tape if there are any gaps, the tape also prevents the skirts from rattling against the body.
hope i helped you out bro.
-Aaron

[jsonpham]

how much did u get the side skirt for on showstoppers and is it type r side skirts?.....please reply thanks

[ep3_civic_si]

Originally posted by Ep3 No.2
test fit them 1st.
depending on which ones u ordered, u will most likely have to sand em down to fit.
the 2 screws up front and 2 screws in the back should be fine, but u might wanna use double sided tape if there are any gaps, the tape also prevents the skirts from rattling against the body.
hope i helped you out bro.
-Aaron

what he said^^^^

[abstrack]

u dont have to sand down the type R ones right?

[redronin22]

You only have to tape the part that flares upwards towards where the i-VTEC sticker is/was. Hope that helps.

[ep3_civic_si]

u dont have to sand down the type R ones right?

if it's the replica u might have to....unless it's like the perfect mold straight from the JDM one then u dont have too, but normally for fiberglass u have to unless it's liek the lips they usually fit perfect