I have DC5 Spoon springs fitted on my CTR. They were guaranteed to be 100% same spec'd as the EP3 springs by a well known and highly reputed dealer. After installation in a shop the front has a 30mm drop in the front and 6mm in the rear.
After some mailing back and forth he claims its recommended to completely remove the rear bumpstops to get an even drop.
Did any of you DIY guys notice if the EP3 rear bumpstops are adding to the ride height? Are they, as a part of their construction, wedged in between the coils and upper mount. Any help is appreciated, guys!
(the 3 more coils on the Spoons will limit the full compression travel by at least 36mm, which should be enough to save the shocks from blowing if the bumstop is removed)
I hope this will also add some fuel to your thread, SiBoy;)
Bookmarks