I have the progress with Greddy EVO 1 and it sits right onthe bar. :sadm:
I've got the stocker muffler on right now with the Progress Sway/Tie Bar + Grey's endlinks. Now at low speeds, I get a little bit of clunking noises.
Has anybody with a stock muffler/Progress sway been able to silence this?
If not, which axle-back mufflers clear the Progress setup with no noise?
I have the progress with Greddy EVO 1 and it sits right onthe bar. :sadm:
Anybody with the stocker?
i shoodnt hit the stock exxhuast ... but i know it hts the HKS :sadm:
sits right on the back of my stock mufler, and vibrates and makes a clunking noised at low rpms
where can i get some exhaust wrap?
www.Summitracing.comOriginally Posted by sai_iii
is there any where that sells just a small amount of it? the smalest one there was like 15 ft haha i dont need that much
it sits right on my hks...also when i had my stock exhuast it rattled and clunked at slow speeds
how much do you need? at the next meet i can give you some. i have some left over from when i did mine.Originally Posted by SoCaLep3
o shiet thanx man...
just enough haha i dunno how much i need but i dont think alot is required...
I know that the magnaflow catback has plenty of clearance for the rear sway
I have the magnaflow and it still hits it.
i got the tanabe racing medallion, it only hits slightly when i start the car but other than that no noise
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks