How long did it take you to dremel that oil pump casing...my dremel burnt up before I could finish..
I was lucky and found a complete shortblock for 300 and I already had the head, so why have a bunch of parts laying around afterwards that I didnt need, so shortblock it was. It wouldnt have mattered if it was a A1 or A4, either would have worked well.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
How long did it take you to dremel that oil pump casing...my dremel burnt up before I could finish..
It took about 10 minutes or so. alot of the newer Dremels overheat rather quickly, after they cool off they usually will start back up.
For major work I use a slightly heavier duty version/copy. 1/3hp with both foot and hand speed controls.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Nicely done my friend. Quality components for a quality build.
Your most reliable source for K24 swap help and warrantied/papered K24 longblocks. Serving the K-community since 2004.
The Evolution:
2003 Ep3 - K24A1/K20Z3 Hybrid - currently under the knife
2001 S2000 - Stock and loving it
1987 Buick T-Type WE4 - The BEAST
HELLZ yeah! Im glad to see this! I was getting depressed at the lack of info from the meltdown..
now im using a corded power drill
good luck on the build. i like your choice of products for the build. one question though. why did you go with a 11:1 compression ratio. wouldn't you have benefited from a higher compression ratio around say 12:1 with those cams?
Well with the extra thick ceramic piston tops, flatface valves and .006" total decking she is just a tad under 12:1, that should be decent.
Think of her as a female Dr. Jeykle and Mr. Hyde...the straight laced Librarian who becomes a true Mrs. Hyde with a penchant for mayhem!
Last edited by talonXracer; 04-19-2008 at 03:22 PM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
with an 11:1 . . .
edit: nvm just read the previous post
so tuned on pump gas?
word! welcome to the bigblock club from somebody in the smallblock club :(
doug, you need to get this beast installed and STAT! lol
this build here is something i REALLY want to do, hopefully soon. This seems to be the best way well for power and torque.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks