My Entry to the BIGBLOCK Club

[Windchaser]

sugoi!

[02_epdriver]

I bet the air will just slide right threw those chambers

[talonXracer]

Here is a pic of the intake ports, before and after porting.

[v1c10us]

thats ridiculous!
so clean, i'll be surprised if you dont open a vortex from the air wizzing past that line.

[shadowmd]

niceeeeeee

[slo_k20]

that's an awesome setup. perfect DD

[talonXracer]

I decided to clean up the drivers side of the Z3 head.


So I found a TSX coolant outlet


I will be removing the outlet for the heater core and useing a AN-10 fitting there. Then I will be smoothing it all out and then having it black powder coated to match the VC and RBC.


As soon as my replacement port grinder gets here I will get to work and then post up some more pics before and after coating.

[dobbs02si]

Looks good man, ports cleaned up nicely. Well, that one atleast haha.

[02_epdriver]

Doug what is your time frame on finishing this and starting her up and gettin some dyno #'s

[72chevel]

So are you going to use E85 with this build?

[02_epdriver]

Doug how is your build comin along

[talonXracer]

Waiting on the rod bearings. Not alot of free time at the moment either....

[02_epdriver]

Must be the busy time of year at work for ya. Are the bearings on back order or you having something done with them?

[Chazwick05]

doug, are you going to be beefing up the journals, or leave them as-is?

[talonXracer]

I am not sure what you are refering to with "beefing up the Journals", I had the crank journals micropolished.

The bearings are on backorder from Honda.