I've been all over the datalogs for 10 minutes and can't figure out what you're hinting at, Jpax.
BTW, I don't see 6th gear in the datalogs, just up to 5th.
what voltage ia the knock level at?
true knock happens around 1.25 vdc
lower than that will still register but it can be attributed to mechanical noise
i once had a 592whp ep on pump gas, i sold it and bought a Z
(heed my advice i know what im doing)
I've been all over the datalogs for 10 minutes and can't figure out what you're hinting at, Jpax.
BTW, I don't see 6th gear in the datalogs, just up to 5th.
i mostly notice the af cmd is all weird from 4600 to 6900 on log 2. Also notices the knock thresh is at zero the whole time.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
does this car have an rbc???
i once had a 592whp ep on pump gas, i sold it and bought a Z
(heed my advice i know what im doing)
hell i have a loose zip tie that whacks the fan when it kicks on and registers knock
i once had a 592whp ep on pump gas, i sold it and bought a Z
(heed my advice i know what im doing)
yeah i know what knock sounds like (jar o'marbles) it was freaking me out untill i got in the garage with the turbo timer on and the fan kicked on and heard a buzzing sound then i went and looked at the CEL and it was going apeshit
only happens with the fan on = not worried about it
i once had a 592whp ep on pump gas, i sold it and bought a Z
(heed my advice i know what im doing)
Ok from the owner its a 5 speed now, Why kpro showed a 6th gear is weird.
the ignition at low RPM 2200~2600 has a nasty dip, and knock occured there, besides the obvious Lean issuses. the cams are only going to 26 degreees, the map says 40
engine is K24A4 so obviously its not going to rotate past 30 becuase the VTC phyusicaly can't do it.
Last edited by Jpax; 04-21-2008 at 10:32 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks