That is the sickest sleeper i have ever seen good luck
Looks stock.........but it ain't.
If you know what a normal K20 looks like in the engine bay, you'll notice that the intake manifold on mine is around 25mm higher
Note the PRB head code and taller block (block difference can be seen near the date stamp in lower right hand of pic)
Block code to prove all the doubters wrong
That is the sickest sleeper i have ever seen good luck
so how much HP gain is this its not very clear..
so you have a k24 crv block and a3 head?
what pistons/rods?
nice work :) looks bone stock but now we can tell the difference
Last edited by Makross; 05-12-2003 at 10:42 AM.
what are the numbers ?
we have a mustang dyno, not a Dynojet
Dynojet numbers are what everyone likes to see....sorry.
it is very much within TSX type HP numbers
nice touch keeping the K20 manifold cover on there. can you say sleeper? nice car, but the last thing i want to do is make this car heavier than it already is. i've got auto-x plans for my EP.
stop usingOriginally posted by Tenacious G
nice touch keeping the K20 manifold cover on there. can you say sleeper? nice car, but the last thing i want to do is make this car heavier than it already is. i've got auto-x plans for my EP.
view new posts
hehe
and get on aim
Originally posted by B18CXr
we have a mustang dyno, not a Dynojet
Dynojet numbers are what everyone likes to see....sorry.
it is very much within TSX type HP numbers
So your running the k20a3 SI head, and internals? what was the cost of this?
Where exactly in the engine bay is that engine code at? I want to find it on my EP.Originally posted by B18CXr
Block code to prove all the doubters wrong
[/B]
So your running the k20a3 SI head,
NO,
PNL ='s SI head
PNA ='s CRV head
PRB ='s RSX-S head
RBB ='s TSX head
nice pics, how much did this cost you?
Sooo... about 200 HP and 165 lb-ft.? I forget what the TSX numbers were.Originally posted by B18CXr
we have a mustang dyno, not a Dynojet
Dynojet numbers are what everyone likes to see....sorry.
it is very much within TSX type HP numbers
I looked at your dyno graph and I notice that the K24/A2 motor relines at 6800 just like the K20A3. Why doesn't it go to 8000rpm and switch to the high lift cam with the A2 head? K24 bottom end won't take the revs?
VERY cool sleeper EP!!
heh, I doubt he's gonna reveal that:D ;)Originally posted by IceD out N CALI
nice pics, how much did this cost you?
I looked at your dyno graph and I notice that the K24/A2 motor relines at 6800 just like the K20A3. Why doesn't it go to 8000rpm and switch to the high lift cam with the A2 head? K24 bottom end won't take the revs?
stock EP ECU....for now.
bottom end WILL handle the revs. see link
www.p1auto.com/jack/movies/sibus8k.MPG
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks