K24a1 swap DIY

[davisj3537]

Yeah I was pretty alarmed when the clip didn't match, but I just swapped my ep knock sensor so no biggie. Papy said it was an 04'. Anyways your probably right about the mounts. If I could move the engine back 3/4 and inch I think it would fit perfect. Do you think adjusting the subframe would make a difference? I''l post some pic's tonight. Thanks again.

Yeah the subframe would definately help a bit...not 3/4 inch though.

[MR.Pizza]

Yeah the subframe would definately help a bit...not 3/4 inch though.

Ok well the hood closes and doesn't hit anything, man it didn't look like it was gonna I swear. Thats a tight fit, like crust on bread. Now I need to bleed my clutch lines.

[tommykair20]

i just swap a k24a2 into my ep3, everything went smooth except that i start the car, car started stumble like gas problem, i thought it was going to go away after a little while but wronggg... car didnt not stop doing it... at first i went straight to the fuel regulator to see if that is the problem, but i keep adjusting it and not getting to the right place where is suppose to be, anyway after i keep changing the fuel pressure of the car i also went to the back of my car to see if the fuel pump is working properly and yes i turn the key pump start sending pressure and if a leave it there for about 6 second stop and release pressure, are my injectors bad??? i just got them like 5 month ago 650cc precision injectors, are they suppose to hold the pressure?or am i just right and my F****** fuel pressure regulator is bad???

[hondaracr07]

anybody got a rough estimate on the price for a swap like this im lookin in to it for like later this summer

[sidriverep3]

ughhh....getting ready to do this swap....again....

[cleanep3]

Whats the Average prices on k24a1 and whats the horse power gains within a3 engine?

[davisj3537]

I know I don't get on here and check on this thread enough but I updated a link and fixed a few things. Posts asking questions about anything other than the install should be addressed in another thread.

[vicx52o]

Can I has free laborz if I answer question's on your behalf?

[davisj3537]

Wouldn't that be nice. lol. I actually think I might quit working on cars...I work too much already and school is wearing me thin. Its getting to the point where I almost make as much money at work as I do on cars.

[vicx52o]

Whaat I see that new job is payin off dude. That's good to hear.

[goldEp]

ok.. so i read and i was paying atention when sombody said.. they used the ep3 base map and bumped it up on fuel..
will it run if I ?? and is it safe if i?? use an ep3 oem none tuned ecu on a k24a1,a2..? with bolt ons..?