K24a1 swap DIY

[talonXracer]

You will be fine running the A3 crank sensor

[03Si757]

Cool thankx.

[davisj3537]

The k24a1 crank sensor and the a1 sensor are the same. I ran the a1 sensor and it was fine. The only reason it needs to be replaced on the tsx motor is the plug wont fit the sensor on your harness.

[03Si757]

Ah, good deal. Again, thanks both of ya. Look for the pics when im done!

[KeNnYtAkEr]

K24A1 Break Down, with Mounts..etc.

[03Si757]

Quick question, If I choose to run OEM Exhaust manifold and Cat from a RSX-S. Would this work? Im having ALOT of trouble with the Type S Race Header I have. It did not clear the sway bar, and its making the b-pipe bang on the bottom of the car. Plus its alot louder now.

[clutch797]

I had that problem and i took it to an exhaust shop and the guy made my downpipe 2 inches longer and the problem was solved. And it only cost me 35 bucks.

[talonXracer]

I had that problem and i took it to an exhaust shop and the guy made my downpipe 2 inches longer and the problem was solved. And it only cost me 35 bucks.

Yeah, most muffler shops will do it for you, it is not much different than what they do all day long.

[davisj3537]

Quick question, If I choose to run OEM Exhaust manifold and Cat from a RSX-S. Would this work? Im having ALOT of trouble with the Type S Race Header I have. It did not clear the sway bar, and its making the b-pipe bang on the bottom of the car. Plus its alot louder now.

I have heard it fits but then also I have had the type s RH fit.

[03Si757]

The problem is the Race Header angels Upward on the bottom of the car, Could that be adjusted? I dont need that much extra space, maybe 1/4 or 1/2 of an inch.

[davisj3537]

The problem is the Race Header angels Upward on the bottom of the car, Could that be adjusted? I dont need that much extra space, maybe 1/4 or 1/2 of an inch.

I removed the heat shield there where the header meets the midpipe and it gave me enough room. I did have a custom mid pipe made though.

[03Si757]

I removed the heat shield there where the header meets the midpipe and it gave me enough room. I did have a custom mid pipe made though.

But see, mine is not hitting the heat shield, and the shield is still on there. its hitting a support on the bottom of the car a little after that. The support was bent were the exhaust lays, but my b-pipe is laying right up against it.

[MR.Pizza]

Is there any clearance issues with the rbc I/M and the k24a1?

[the JigGa mAn]

i know you have to get the CRV passenger side motor mount, what if you want to use a better mount like the innovative motor mounts? do they make a kit that comes with the CRV passenger side mount?

[davisj3537]

i know you have to get the CRV passenger side motor mount, what if you want to use a better mount like the innovative motor mounts? do they make a kit that comes with the CRV passenger side mount?

The mount kit replaces a different piece of the mount...you still need the crv mount. It is only like 20 bucks man.