Buddy club pro spec?

[zuzu89]

I have a dc race header
and a buddy club prospec exhaust
did anyone who has this setupp have a fitment problem
my exhaust rattles against my progress rear sway LIKE CRAZY VERY VERY ANNOYING
does any one have any solutions to make this go away

[ep3moschini]

I never had a problem with that same set-up

[zuzu89]

its probably the most annoying noise in the word i think its just my luck and this car

[ep3moschini]

its probably the most annoying noise in the word i think its just my luck and this car

throw some heat wrap arround the exhaust pipe where its contacting your swaybar, or adjust your swaybar so its not making contact the best way to do this it to set the rear end on jackstands and then add preload to the trailing arm then adjust it

[zuzu89]

i kno this is a dumb question but idont meet jdm standards on car knwledge what does "then add preload to the trailing arm then adjust it" mean exactly

[SpAdZ]

i just started to have this prob...i am running a skunk2 70mm and the progress 24mm sway...i have the sway set as far down as it can go...for now i used two extra energy sustension bushings and put them between the exhaust and sway bar but soon ill bend the hangers a bit to get it to sit away from the sway...also have a slight knocking with the middle of the pipe...hopefully the bends solve both problems

[zuzu89]

i have the worst luck with the ep
so im not surprised
wen i first bought it EBAY EXHAUST
amazing fitment no problem
then i wanted to go real jdm and got prospec n its not fitting to great

[ep3moschini]

i kno this is a dumb question but idont meet jdm standards on car knwledge what does "then add preload to the trailing arm then adjust it" mean exactly

put the car on jackstands, then put a floor jack under the trailing arm and jack it up until the suspention is loaded (up but not enough to lift the car off the jack stand)

[zuzu89]

i kno i meant like how do u adjust it

[ep3moschini]

i kno i meant like how do u adjust it

do you have adjustable endlinks? either that or try to loosen the bar and move it out of the way (side to side, or front to back)

[zuzu89]

EP3MOSCHINI you are a genius at life

[ep3moschini]

EP3MOSCHINI you are a genius at life

dont you jinx me!!!

[zuzu89]

your car is an idol too me

[Deadphishy]

Good luck man. You might need to take it to a muffler shop so they can put longer hangers on it. Most Aftermarket stuff is tested only on a stock set-up. So two aftermarket items might not fit together perfect.

[zuzu89]

thanks ryan
u always have the answers where do u suggest s&k or wearmasters