help with DIY For DCRH and injen CAI

[todaamann]

I've got a DCsports rade header and an Injen CAI i need to install, and have never done it bofore... please help, somebody!! pics appreciated..

[todaamann]

i don't know where else to look for DIY... i just keep finding threads of how good the power gains are, and im going crazy!!! i want that freakin header on now!!

[4angrybadgers]

If you bought the DCRH new it will have instructions. Just follow them, take your time, and you'll be fine. As for the CAI, just remove the stock intake and put in the new intake... it's not that hard.

[v1c10us]

^ you have to have pitty on people who want to mod cars but cant remember basic things like, righty tighty, lefty loosey, or who cant figure out that when putting a new header where the old one was that you should.

1. remove the bolts
2. remove the header
3 put in the new header
4 put in the bolts.
5. tighten the bolts.

or in the case of an intake.

1. take a screwdriver and un screw clamps.
2. unscrew bolts holding air box.
3. remove airbox
4. remove rubber intake doodad.
5. realize you left all the little pluggys plugged in
6. un plug them
7. put in new intake
8. connect pluggys to pluggy slots
9. tighten stuff with those big bracelets you took off earlier.
10. start car and then lose gas mileage cause you like the sound and now you floor it everywhere.

[todaamann]

thanks.. i actually got the header on no problem (without the detailed instructions).. i just wanted to see it all before i took everything apart. sorry? :\

[dmon]

^ you have to have pitty on people who want to mod cars but cant remember basic things like, righty tighty, lefty loosey, or who cant figure out that when putting a new header where the old one was that you should.

1. remove the bolts
2. remove the header
3 put in the new header
4 put in the bolts.
5. tighten the bolts.

or in the case of an intake.

1. take a screwdriver and un screw clamps.
2. unscrew bolts holding air box.
3. remove airbox
4. remove rubber intake doodad.
5. realize you left all the little pluggys plugged in
6. un plug them
7. put in new intake
8. connect pluggys to pluggy slots
9. tighten stuff with those big bracelets you took off earlier.
10. start car and then lose gas mileage cause you like the sound and now you floor it everywhere.

lol to that step

[v1c10us]

yeah..
my favorite was connect pluggys to pluggy slots.

[2004ep3hatch]

Well since it looks like you got the answer i will close this out and move it to the right subforum so people can see. also its best to lower the front sway bar to help.