DIY: SRS light reset

[SiR R8TD]

Thank you! I am new to the EP3 world, and just acquired an 02 fixer upper.

1 item down... a million to go.

I do have a suggestion, I found it hard to insert and take out the paper clip fast enough so I did the following :

- I used 2 paper clips straighted out, one in each contact.
-When ever I wanted to (Insert) the paper clip, as per the instructions, I just squeezed the paper clips to complete the link.

_when ever I needed to (remove) the paper clip, I just separated both paper clips from each other.

Again, thanks, and hope this helps.

Roberto

Yeah, that works too. It's a pain to get the timing at first. I've done a few cars, & it gets easier.

[sittinlow]

neat

[3dkahuna]

This worked just great, but unfortunately my srs unit was bad, so the stealership replaced it. They covered the cost of it though. They thought they damaged it when they did my body work on the car.

[xachary82]

finaaaaaally I dont have to drive at night with a bright red glow coming from my gauges!!! thank you so much

[blksi02]

handy DIY!! used this many times... That damn Amplifier

[sk8civic03]

I have stock seats and a stock steering wheel and my srs light just came on. I did this and it works until I plug the yellow connector back in, so does that mean my srs unit is bad?

[lildewd]

My dealer charged me $90 (hour rate) to tell me I needed a new seat belt buckle ($400), after I told him I believed it was a reset issue. Thanks a million.
I'm gunna print this thread and take it in to him, see if I can get my money back! They are clueless. Must be a canadian thing. lol

[SiR R8TD]

My dealer charged me $90 (hour rate) to tell me I needed a new seat belt buckle ($400), after I told him I believed it was a reset issue. Thanks a million.
I'm gunna print this thread and take it in to him, see if I can get my money back! They are clueless. Must be a canadian thing. lol

Good luck! You have no way of knowing the buckle was defective or not, but give it a shot.

[lildewd]

Ya, it worked, just like you said it would..........

[crhatch02]

i have tried this so many times but I cant seem to get it to work

[Sucka]

i have tried this so many times but I cant seem to get it to work

same here. maybe i have aftermarket seat belt since i got new seats with new seat belt.

[SiR R8TD]

i have tried this so many times but I cant seem to get it to work

If it doesn't work at all, you may have an SRS problem which you should get checked out. Good luck.

[az-epdrvr]

whats wrong if light comes back on , after doing all this ?

[SiR R8TD]

whats wrong if light comes back on , after doing all this ?

You have an SRS problem. I you get a scan tool, you can pull SRS codes I believe.

[Unknownally]

My light is still on. Step 7 says to put it on "OFF." I put it on "I." The ignition is still off, right?

How much will the stealership charge?