K20z1 Swap Q's

[Jpax]

$170 for that ouch.

[whitt]

Check this link out and click on the Kswap tab on the left. VSS convertors.
http://www.dscustoms.com/s2000cluster.htm

Right I do remember this guy. I just wasn't sure if this is how people were making the speedo work. Also, will this fix the no vtec issue hondata mentioned?

[Jpax]

Right I do remember this guy. I just wasn't sure if this is how people were making the speedo work. Also, will this fix the no vtec issue hondata mentioned?

Where did you read that? I would assume that if they do have an upgrade you did get that fixed too. link please

[whitt]

$170 for that ouch.

Yeah I think Imma get punched in the face!

[whitt]

Where did you read that? I would assume that if they do have an upgrade you did get that fixed too. link please

http://www.hondata.net/forum/viewtop...&highlight=vss

Hope this makes sense, cause I was bummed.

[Jpax]

LOL your funny. while kpro is open Im loooking at the Vtec Tab and the Options section for vtec is ready to be clicked meaning it can be used. so you can use the switch, or and the VTC will work too, and you can Cam it and diable any errors from performance cam shafts might throw.

and i read that link

Under the Tab Misc you can TURN ON A constant SPEED SIGNAL meaning it will work with Vtec.

[whitt]

Right on man. I just hate dealing with this part of swaps. I don't mind turing the wrench, but dread wiring and sensor issues. I had a nightmare when I swapped the lude from odb I to obd II.

http://www.hondata.com/techk20transmissions.html

This link may help out others in the same situ.

[whitt]

I found this also and it appears it may be the answer.

http://www.dakotadigital.com/index.c...rod/prd126.htm

All in all I may end up just switching trans cases. I hate wiring issues, and would not know where to put the convertor box. Any suggestions on what might be best?

[03Si757]

Yeah I think Imma get punched in the face!

Make sure you post a vid and sound clip of that