Boost Gauge
1.
Placing Boost Sensor
The rubber hose attached to the sensor should be short as possible for more accurate reads.
2.
Wire paths
-Engine Bay-
Side-View
There is rubber Gromet hole; which is for OEM Fog light harness.
You basically run the wire through there into inside of the car.
-Inside of the car-
Wire directly goes into back of the Control Unit.
-Boost Gauge to Control unit-
Using Meter Wire.
You will see small feeding hole right by streering column.
-Check all connections, then start the car to see everything works-
1) Make sure brightness of Defi-Link meter illumination can be adjusted.
2) Make sure gauges perform the opening mode
All Installed
Bookmarks