How do we replace these???
I heard you can pound these out after the rotor is removed ....
ONLY the rears though
ideas??
remove the wheel. remove the rear caliper. remove the rotor. line up the broken stud with the hole in the knuckle and hit it out with a hammer. put the new stud in through this hole and either hit it in with a hammer and punch, or get some shims and a 12x1.5 pitch nut and pull it through.
Last edited by MugsyTheGr8; 05-05-2008 at 02:35 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks