remove the bolts, remove usdm rebar. Install jdm rebar and reuse existing bolts. Don't forget to reinstall the foam padding.
You'll need an extension to reach the bolts.
Approx. 10 minutes after you remove your bumper
More importantly what tools do i need to install? I can imagine it is pretty self explanatory when you're looking at it, just want to make sure i have the right tools while i have the bumper off :)
remove the bolts, remove usdm rebar. Install jdm rebar and reuse existing bolts. Don't forget to reinstall the foam padding.
You'll need an extension to reach the bolts.
Approx. 10 minutes after you remove your bumper
i found it alllot easier to just move the headlights out of the way...easier in the long run imo
just did mine yday with the help of ep88...JDM FRONT END!!! woot woot!
make sure u have a 10" extension.. makes it smooth install
I trimmed about an 1 inch from both sides maybe more if I remember correctly and then taped it to the jdm rebar. It fit fine with jdm bumper.
Like everyone said your going to need an extension and I believe a 12 mm socket. It's pretty straight forward from there.
the easiest way is to take a hammer to it. a hammer will fix anything and everything.
So what goes on first? Bumper support or headlights?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks