Close

Results 1 to 4 of 4
  1. #1
    No Fat Chicks Danman281's Avatar
    Join Date
    Apr 2008
    Location
    H-town
    Posts
    265

    DIY - Ebay Fog Switch to LED's

    Tools needed:
    Soldering Iron
    Rosin 60/40
    2x 510 Resistors
    1x 3mm green LED
    1x 3mm clear amber LED
    Ebay Fog Switch
    Small Drill (about 1/16)

    This is a follow up from my old thread:
    http://www.ephatch.com/forum/showthread.php?t=44933






    tip: you can use hot glue to add a layer of insulation to keep the resistor from touching the switch. Its up to you
    Last edited by Danman281; 05-12-2008 at 09:10 PM.

  2. #2
    Site Sponsor oneglory's Avatar
    Join Date
    Apr 2004
    Location
    NJ
    Posts
    1,470
    nice, thanks for this.
    Ed~

  3. #3
    ΜΟΛΩΝ ΛΑΒΕ talonXracer's Avatar
    Join Date
    Apr 2004
    Location
    Catskill Mtns
    Posts
    9,252
    Not a bad fix, but a new OEM switch is only 14$ and a far better choice for most everyone without any electronics experience.
    ALL advice issued with this "Disclaimer"
    Tim "the Toolman" Taylor is my HERO ! ! !

    "Labor Unions are Domestic Terrorist orgainizations"

  4. #4
    No Fat Chicks Danman281's Avatar
    Join Date
    Apr 2008
    Location
    H-town
    Posts
    265
    Quote Originally Posted by talonXracer View Post
    Not a bad fix, but a new OEM switch is only 14$ and a far better choice for most everyone without any electronics experience.
    Where do you buy your OEM switches from? I would have bought one if I knew it was that much because I bought my fog switch from Acura for ~$30 since they do not sell the switches seperately

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •