Use the Innovative mounts, they are well worth the money and work better.
ETD will be fine on a k24......tho innovative mounts are your best bet....I wouldnt use a ETD myself either.....just doesnt seem right that it only hooks up in one spot and on one side of the engine.....seems like it would create some side to side tension between the motor and the chassis.....maybe if you had an etd installed in four spots...seems like it would put too much stress on that one strut tower too....
Use the Innovative mounts, they are well worth the money and work better.
yeah i think its a great thing to have, but i didnt think about the whole k24 being taller and possibly throwing off the "points" on which this etd was designed. the one i have is for a k20a3 - not a k24. if its not recommended from the manufacturer, then they put up that warning for a reason... and with my luck something will happen. lol
eventually i will switch over to better mounts... but i had the etd and wanted to put it on, until i saw that.
i was just curious if they made ones for swapped ep's... i guess not yet.
thank you everyone for your input and advice, its very much appriciated.
I rocked out the etd on my k24a1 and it fit almost the same as it did on the a3.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks