Swapped ep's - anyone running an ingalls ETD?

[SyckSiR]

ETD will be fine on a k24......tho innovative mounts are your best bet....I wouldnt use a ETD myself either.....just doesnt seem right that it only hooks up in one spot and on one side of the engine.....seems like it would create some side to side tension between the motor and the chassis.....maybe if you had an etd installed in four spots...seems like it would put too much stress on that one strut tower too....

[wil524]

Use the Innovative mounts, they are well worth the money and work better.

[SinisterCivicSi]

she never said it was bad to use...she said when she bought it..she didnt read where it said she couldnt use it on swaps and mary has a k24 swap in her ep3.

yeah i think its a great thing to have, but i didnt think about the whole k24 being taller and possibly throwing off the "points" on which this etd was designed. the one i have is for a k20a3 - not a k24. if its not recommended from the manufacturer, then they put up that warning for a reason... and with my luck something will happen. lol

Use the Innovative mounts, they are well worth the money and work better.

eventually i will switch over to better mounts... but i had the etd and wanted to put it on, until i saw that.

i was just curious if they made ones for swapped ep's... i guess not yet.

thank you everyone for your input and advice, its very much appriciated.

[davisj3537]

I rocked out the etd on my k24a1 and it fit almost the same as it did on the a3.

[clizoman]

yeah... i didnt think about the k24 being taller... shit... i gotta sell mine now.

it works with my k24. youre just not mounting it right. and yes it fits and its functional. the deck height has nothing to do with the height of the motor. the triangle mounting spot on the k24 is lower.