i'v had my Neuspeed short shifter adapter for almost a year, and i haven't run into any problems
I have thought about getting a short shifter installed in my ep. But I have heard people say that it is not good for the tranny on ep3's. I would like to get some more information on this! Are there any problems that could cause damage from using a short shifter in a ep tranny?
thanks!
i'v had my Neuspeed short shifter adapter for almost a year, and i haven't run into any problems
get the buddy club...the neuspeed makes the shifter look stupid....
the feel of shifting is the same with the aluminum bushings IMO
Forget about the POS Neuspeed short shift adaptor and go with the BC shifter if you want to reduce the shift pattern.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
The BCSS (and I'm assuming the Neuspeed as well) will not cause any damage to your transmission. There's been musing as to whether a heavy shift knob like the Skunk2 would be bad for your synchros (I don't know either way), but a short shifter by itself will cause no damage.
i am confused on how a short shifter of any type could damage or cause problems in the tranny since the change in throw distance and stiffness is all done at the shifter assembly itself.
on the latter note, definatly get the buddy club short shifter.
does the BCSS workw ith 6 speed?
i just got my BCSS in the mail and it's for EP3 butit says 5 speed on the side.. but i have a 6speed tranny?
BCSS FTMFW...get a set of the shifter bushings also if u want even tighter feel!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks