mmm....
very nice!
Well this picture should just about sum up my weekend...
***UPDATE***
Here is one of the Hotchkiss endlinks after just 8 months, including 1 winter in upstate NY.
And here we have the LCA and Coilovers installed,
OH yes a ITR sway bar is on it's way, there is no way to adapt this kind of difference.......
***UPDATE***
Here is a pic comparing the ITR vrs EP3 front sway.
***UPDATE***
Well I finally replaced the lower ball joint boots and got the fronts fully assembled. The toe is way off and I cant get in for an alignment till thursday, so I will take a few trips around the block and get it close enough to drive to the alignment shop safely. I didnt have my torch available to cut the rear MugenSS out, but I did change out all the corroded Hotchkiss endlinks for OEM ones. Notice the liberal use of anti-sieze during reassembly!!!
Last edited by talonXracer; 06-09-2008 at 01:05 PM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
mmm....
very nice!
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
Yeah the MugenSS blew their wad some miles ago. Maybe I will remove the Showa dampers, install a set of Konis and sell them.
Oh, and seeing as the struts are DC5 spec, I have a set of typeS tierod ends to swap out as well. The BITCH will be the rear struts lower bolt, they are both "frozen"....
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
ouch.
sounds like you need to move to a warmer climate...lol
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
are those the progress coilovers?
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Holy $hit Doug....you're powerwashing the driveway!
Mel
That is the garage floor
A full winters worth of crap on the floor
Because it has a blacktop floor and not concrete it isnt considered a permanent improved structure for tax purposes.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Just busting your stones.
Nice purchase. Looking forward to your write up / review.
Mel
very nice project you got....cant wait to see the results!
what company makes those LCAs?
looks fun......but I am not so sure the em2 bar is going to work with the wider type-r LCA.....
Looks like fun. Maybe you can get a diy up after your all done?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks