Boost gauge is independent from the map sensor. If the gauge is reading 15 psi then you are hitting 15 psi. Which is not good. Get a 3 or 4bar map sensor asap. And get rid of that pos bc. Check ur vac lines for leaks or cuts. I would turn down the boost and set a boost cut for 8psi....
u dont have to get a retune with the 3 or 4 bar map. get the hondata 4 bar, and just go into parameters and select omni 4 bar, and upload. its scalar, so itll run the same.
and ur overboosting, take off the bc. u might blow up. just run whatever the wastegates runs, as long as it lower than 10 psi. sell the bc and buy a 4 bar and a spring for the boost you want. or maybe a hondata bc.
adam
haha, damn, caught. no he does really good tuning, and im starting to tune on my own. i tuned my setup, but idle and some parts of my ignition are crapy, and i dont know how to fix it so i figured i could referance how to do it right.
i would tho, seriously, get ur boost lower than 10 psi tho, if evans tuned only to 9.7, then ur only safe on not blowing up up to 9.7.
adam
just ordered my race harness innov motor mount on crsx.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks